Curing

 

A controlled three-phase cycle

Curing, or heat treatment, accelerates the strength gain of the concrete. The cycle is run gradually, so as not to weaken the piece:

  • Temperature rise, gradual, to avoid concrete shrinkage
  • Holding, until the concrete has fully set
  • Cooling, gradual, so as not to over-stress the segment

 

Equipment suited to your plant

  • In a carousel: the moulds pass through an insulated curing chamber, at controlled temperature and humidity. The heating (steam, hot-water circuit or electric) is chosen to optimise time, cost and energy use. CBE sets the cycle, controlled from the PLC: temperature and humidity are regulated automatically by probes.
  • In a stationary plant: the moulds are covered with insulating tarpaulins and steam-heated in place.

 

Key benefits

  • A controlled temperature rise and cooling, to limit segment defects
  • Accelerated concrete set, supporting the production rate
  • Heating chosen to optimise energy use
  • In a carousel, a cycle set by CBE and automatically regulated by probes

Zyskaj więcej z naszej strony dzięki plikom cookie.

Nasza strona internetowa używa plików cookie, aby m.in. zapewnić najlepsze wrażenia użytkownika i śledzić statystyki odwiedzin.

Akceptuję wszystkie pliki cookie Odrzuć pliki cookie Ustaw swoje preferencje