Curing

Curing is a key step for the proper hardening of the concrete and the quality of the segment: a controlled temperature rise accelerates and secures the concrete set. CBE adapts the curing equipment to the type of plant and to the project's requirements.

 

A controlled three-phase cycle

Curing, or heat treatment, accelerates the strength gain of the concrete. The cycle is run gradually, so as not to weaken the piece:

  • Temperature rise, gradual, to avoid concrete shrinkage
  • Holding, until the concrete has fully set
  • Cooling, gradual, so as not to over-stress the segment

 

Equipment suited to your plant

  • In a carousel: the moulds pass through an insulated curing chamber, at controlled temperature and humidity. The heating (steam, hot-water circuit or electric) is chosen to optimise time, cost and energy use. CBE sets the cycle, controlled from the PLC: temperature and humidity are regulated automatically by probes.
  • In a stationary plant: the moulds are covered with insulating tarpaulins and steam-heated in place.

 

Key benefits

  • A controlled temperature rise and cooling, to limit segment defects
  • Accelerated concrete set, supporting the production rate
  • Heating chosen to optimise energy use
  • In a carousel, a cycle set by CBE and automatically regulated by probes

Get more out of our website by using cookies

Our website uses cookies to, among other things, give you the best user experience and to track visitor statistics.

I accept all cookies Refuse cookies Set up your preferences